Filter
Top Products
21
A
A
B
C
A
MB3150-GB
Figure 40
Figure 41
Figure 42
Adjusting the seat depth
Figures 40, 41 and 42
The depth of the seat is adjusted with the
help of the seat extension piece (41A).
Seat extension pieces of 3 cm and 5 cm
are supplied with the wheelchair. If the
wheelchair is fitted with seat extension
pieces, a plug (41B) is provided in place
of one of the pieces.
The table on page 31 shows which
seat depths can be achieved on your
wheelchair.
To extend the seat:
Unscrew screw (40A) Remove the plug
or seat extension piece at the front of
the seat tubing. Loosen the overlapping
Velcro in the seat fabric and pull the seat
cover forward (42A). Place the plastic
tube (3C) into the fold of the seat fabric
inside the seat tubing. Assemble the seat
extension piece (41A).
Insert the screws (40A) and tighten.
To shorten the seat:
Unscrew the screw (40A). Remove any
seat extension pieces at the front of the
seat tubing. Loosen the overlapping
Velcro in the seat cover and pull the cover
towards the seat back (42A). Insert the
screws (40A) and tighten.
Adjusting the chair