Filter
Top Products
19
A
A
MB3150-GB
Figure 36
Figure 34
Figure 35
Adjusting the curvature of the
back
Figure 34
The wheelchair has a padded back that
can be adjusted to the curvature of the
back in order to achieve a comfortable
sitting position and good stability.
The user can sit in the wheelchair when
adjustments are being made for the
curvature of the back.
Loosen the back cover in order to access
the Velcro tapes. These can be adjusted to
change the back curvature and so achieve
maximum comfort and support.
Adjusting the brakes
Figures 35 and 36
The standard wheelchair is delivered with
brakes that are fitted in the middle driving
wheel position.
In order to move the brake, loosen the
screw (35A) that is located on the inside
of the frame at the front of the wheelchair.
Move the entire brake in the track to the
desired position. Correct distance between
the brake block and the wheel (36A) is
approximately 2.5 cm.
The brakes that are supplied with the
wheelchair will not normally need to be
adjusted.
Adjusting the chair