Filter
Top Products
18
1
5
10
5
0
-5
A
B
B
C
A
C
MB3150-GB
Figure 31
Figure 32
Figure 33
Adjusting the height of the back
Figure 31
In order to access the back tubing when
adjusting the back height, open the “lid”
(C) in the back cover. The measuring
scale (31A) shows the back height. For
easier access to the back tubing, raise the
pushing handle. The adjustment can be
made whilst the user is in the wheelchair.
Additionally, it is not necessary to remove
the driving wheels in order to adjust the
back height.
• Loosen the screw in the back tubing
(31B)
• Adjust to the desired back height. See
the measuring scale
• Re-tighten the screw
Adjusting the angle of the back
Figures 32 and 33
The angle of the back can be adjusted
from –5° to 15°, in intervals of 5°. The scale
showing the back angle (33A) is located
on the back fitting bracket. The adjustment
can be made whilst the user is sitting in the
wheelchair. Additionally, it is not necessary
to remove the driving wheels in order to
adjust the back angle.
• Loosen screw (33B) approx. 5 mm
• Pull out the lock ring (33C), adjust the
angle of the back and release the lock
ring at the desired angle
• Re-tighten screw (33B)
Adjusting the chair