Filter
Top Products
Wiring diagram
P 17/17
Fig. D-6
[3] Connecting Connector Housing with Brush Holder Unit
Rear cover
The side where Lead wires are drawn out must be placed on Rear cover side as illustrated blow.
to Controller
on Handle base
Connector housing A
Connector housing B
(if used)
Motor housing
Choke coil
(if used)
Connector housing is directional when connected with Brush holder complete in Motor housing.
Be sure to connect as described in Fig. D-6.
2. Do not put Lead wires on Connector
housing(s) or Lead wires will be
pinched between Handle base and
Motor housing.
[DO NOTs]
1. The side where Lead wires are drawn out
must not be placed on the opposite side to
Rear cover.
side where Lead wires
are drawn out