Filter
Top Products
Wiring diagram
P 15/17
Fig. D-4B
Fig. D-5B
[2] Wiring in Handle Base and Handle
Low Voltage Areas where Radio Interference Suppression Is Required
The Lead wires to Connector
housing A must be tight between
Controller and Lead wire holder.
Terminal of Grounding wire
Grounding wire (clear)
Controller
Put the slack portion of
Lead wires in this space.
Route all of the Lead wires
to Switch through between
the boss and the rib.
Fix all of the Lead wires to Switch
with this Lead wire holder of
Switch holder complete.
Handle Base,
viewed from Handle side
Handle, viewed from Handle cover side
Noise suppressor
Switch
Switch holder
Pass Controller’s Lead wires covered
with Polyolefin tube (black) between
Switch and Switch holder's wall.
boss
rib
Handle base,
viewed from Controller side
Pass the following Lead wires
through this hole:
*Noise suppressor's Lead
wires (black)
*Controller’s Lead wires covered
with Polyolefin tube (black)
*Lead wire (red) from
Connector housing A
*Controller's Lead wire (white)
Pass Grounding wire (clear)
through the hole illustrated
to right in Fig. D-2.
red
white
Route all of the Controller's
Lead wires and grounding
wire (clear) through this slit.
Fix the following Lead wires of
Controller with this Lead wire holder:
*Grounding wire (clear)
*Lead wires (black, red) to Connector
housing A
Controller
Connector housing A
Lead wires covered with
Polyolefin tube (black)
Pass these Lead wires from Controller
and Connector housing A through
the hole illustrated to right in Fig. D-2.
Grounding wire (clear)
Fix Grounding wire (clear)
with this Lead wire holder.
Put the slack portion of
Grounding wire in this space.
Fix Grounding wire (clear)
with this Lead wire holder.