Filter
Top Products
Customer Service 1 800 227-8862 11
1. Check the code on the test strip vial before
inserting the strip
Code numbers are used to calibrate your meter
with the test strips you are using.
2. Insert a test strip to turn on the meter
Start with the meter off. If you have turned the
meter on to change settings or review past
results,turn it off. Remove a test strip from its vial.
With clean, dry hands, you may touch the test
strip anywhere on its surface. Do not bend, cut
or modify the test strips in any way. Use each test
strip immediately after removing it from the vial.
Insert the test strip into the test port as shown.
Make sure the three contact bars are facing you.
Push the strip in as far as it will go. Do not bend
the strip.
After the black start-up screen appears, the
meter will display the code from your last test. If
a flashing “––” appears instead of a code number,
such as when you are first using the meter, follow
the instructions on the next page to change to a
numerical code.
Starting the test process
DCO_06344501B_OU2_OB_USe.qxd 12/21/05 8:03 AM Page 11