Filter
Top Products
53
Entering Set-Up Mode
1. Make sure the meter is off.
2. Press and hold down the green
C button.
3. Press and release the blue
power button while holding
the C button.
4. Release the C button.
In the set-up mode, the current set-
ting for each of the three changeable
features is automatically displayed
in sequence. Each setting flashes
on the display for five seconds.
While it flashes, the setting may be
changed by pressing the C button.
After the last feature is displayed,
the meter automatically turns off.
To re-enter set-up mode, begin with
Step 2.
Display of Last Result
The SURESTEP
®
Meter is pre-set to
automatically display your last test
result when you turn on the meter.
After you release both the power and
C buttons, this symbol will flash on
the display:
SETTINGS
LSI-98-090 SS booklet.B 7/13/98 11:41 AM Page 53