Filter
Top Products
31
9. Accessories
The macroscopes are equipped with motorized
cross-stages.
Stage surface: 160 mm x 220 mm
Glass stage plates: 80 mm x 80 mm
Travel range of the stage: 50 mm x 50 mm
On the stage surface, there are threaded bore
holes as receptacles for the adjustable holder
(universal holder), rotating stages ø 118 mm,
bullet manipulators K2715A, large sample stages
and rotating device for toolmark examinations.
For transmitted light, removable glass stage
plates are also provided (Fig. 31).
Rotating stages ø 118 mm
Rotating stages, which can be stacked on the
basic equipment cross-stages (Fig. 32), are fas-
tened using two Allen screws. They are suitable
for incident light and transmitted light examina-
tions. The rotating stages each have one open-
ing in the center, which is sealed with a remov-
able glass plate (32.3). The threaded bore holes
on the stage surfaces are provided for screwing
on the adjustable holder. Additionally, there are
also holes for inserting the stage clips. The ro-
tating stage surface can be locked into place
using a fastening screw (32.2).
In the bottom parts of the rotating stages, there are
receptacles for inserting the polarizers (32.1) with
λ-plates (red = OK). These can be rotated 90°.
Fig. 32 Rotating stage ø 118 mm
1 Filter slot for polarizer
2 Fastening screw
3 Glass plate
Fig. 31 Table with glass stage plate
9.2 Stackable Stages
3
2
1