Filter
Top Products
56
C. Connect the limit switch. Refer to DISCONNECT-
ING/CONNECTING LIMIT SWITCH in this PRO-
CEDURE 8 of this manual.
17. Reinstall the battery boxes. Refer to
INSTALLING/
REMOVING BATTERY BOXES in this procedure of
the manual.
18. If necessary, install the front and rear shrouds. Refer
to
REMOVING/INSTALLING SHROUDS in PROCE-
DURE 10 of this manual.
FIGURE 18 - REPLACING WIRING HARNESS - 16, 18, AND 20-INCH WIDE MODELS
Tie Wraps
(STEPS 8, 16)
Charger Cable Mounting Bracket
Wiring
Harness
To Controller
(STEPS 4, 15)
Phillips Screws
(STEPS 7, 13)
Spacers
(STEPS 5, 11)
Locknuts
(STEPS 6, 12)
Phillips Bolts
(STEPS 6, 12)
Phillips Screws
(STEPS 5, 11)
Phono Jack
Nut
Phono Jack
Side
Shroud
14. Resecure the wiring harness and motor cables to the
crossbraces with new tie wraps at the positions noted
in STEP 8.
15. Connect the wiring harness (BLUE) to the controller
connector (BLUE).
16. HIGH BACK CAPTAIN'S SEAT MODEL WHEEL-
CHAIRS ONLY - Perform the following:
A. Position the new phono jack on the side shroud.
B. Reinstall the phono jack nut onto the new phono
jack and tighten securely.
PROCEDURE 13 FWD WHEELCHAIRS
F
W
D
W
H
E
E
L
C
H
A
I
R
S