Filter
Top Products
48
NOTE: Make sure vertical portions
of both handles are in line.
Set Screw
FIGURE 10 - INSTALLING OPTIONAL CLUTCH
EXTENSION HANDLES - MOTORS WITH CLUTCHES
ONLY
Clutch Extension
Handle
Motor
Remove
Rubber Tip
if Equipped
Clutch
Handle
INSTALLING OPTIONAL CLUTCH
EXTENSION HANDLES - MOTORS
WITH CLUTCHES ONLY (FIGURE 10)
1. Turn the power to the wheelchair to the OFF position.
2. Position the clutch extension handle by the clutch
handle on the motor as shown in FIGURE 10.
NOTE: If the clutch handle on the motor is equipped with
a rubber tip, remove the rubber tip before installing the
clutch extension handle.
3. Slide clutch extension handle onto the clutch handle
on the motor.
NOTE: If necessary, lightly tap the clutch extension handle
onto the clutch handle with a plastic mallet. Make sure
the vertical portions of both handles are in line.
4. Securely tighten set screw on clutch extension handle.
5. Repeat STEPS 2-4 for opposite side of wheelchair.
W
H
E
E
L
S
/
A
N
T
I
-
T
I
P
P
E
R
PROCEDURE 12 WHEELS/ANTI-TIPPER