Filter
Top Products
TRANSPORTING
P9000
™
XDT 66 Part No. 1118386
TRANSPORTING
ƽ WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Transporting the P9000 XDT
ƽ WARNING
The weight of the wheelchair without the user and batteries is approximately 82 lbs.
Use proper lifting techniques (lift with your legs) to avoid injury. Extreme caution is
advised when it is necessary to move an unoccupied power wheelchair. Invacare
recommends using two (2) assistants and making thorough preparations. Make sure
to use ONLY secure, non-detachable parts for hand-hold supports.
NOTE: For this procedure, refer to FIGURE 15.1.
Unfolding/Folding the Wheelchair
ƽ WARNING
Keep hands and fingers clear of moving parts to avoid injury.
DO NOT place hand or fingers on the underside of the seat rail when opening or
closing the wheelchair.
DO NOT sit or transfer into the wheelchair unless it is fully open and the seat rails
are fully seated into the side frame H-blocks.
Unfolding
1. Push down on the seat rails until the seat rails are positioned in the seat guides.
2. Assemble the wheelchair by following the instructions in this manual.
Folding
1. Remove the anti-tippers. Refer to Installing/Removing/Adjusting Anti-Tippers
on
page 64.
1. Remove the batteries. Refer to Removing/Installing the Battery Boxes on page 50.
2. Remove the footrests/legrests from the wheelchair. Refer to
Installing/Removing/Using the Footrest/Legrest on page 34.
3. Remove the battery tray from the wheelchair. Refer to Installing/Removing Battery
Tray on page 51.
4. Lift up on the seat rails of the wheelchair.