Filter
Top Products
SECTION 7—ARMS
Part No. 1118386 39 P9000
™
XDT
Swing-Back Arms
ƽ WARNING
Make sure the armrest release lever is in the locked position before using the wheel-
chair.
NOTE: For this procedure, refer to FIGURE 7.2.
1. Unlock the swing-back arms by rotating the armrest release lever towards the outside
of the wheelchair.
2. Pull the front of the swing-back arm straight up/out of the arm socket and towards the
rear of the wheelchair.
3. To use the swing-back arm, push the swing-back arm towards the front of the
wheelchair and then downward into the arm socket.
NOTE: Armrest release lever MUST be in the unlocked position when placing armrest into the
arm sockets.
4. Lock the swing-back arms by rotating the armrest release lever towards the inside of
the wheelchair.
FIGURE 7.2 Swing-Back Arms
Replacing Armrest Pad
NOTE: For this procedure, refer to FIGURE 7.3
1. Remove the mounting screws that
secure the armrest pad to the armrest
assembly.
2. Replace armrest pad and securely
tighten with the existing mounting
screws.
FIGURE 7.3 Replacing Armrest Pad
Front
Armrest Release Lever
Arm Socket
Rear
Swing Back Arm
Armrest Pad
Armrest Assembly
Mounting
Screws