Filter
Top Products
SECTION 11—BATTERIES
P9000
™
XDT 52 Part No. 1118386
Installing/Removing Batteries Into/From Battery Boxes
ƽ WARNING
Make sure power to the wheelchair is OFF before performing this procedure.
The use of rubber gloves and chemical goggles or face shields is recommended
when working with batteries.
Invacare strongly recommends that battery installation and battery replacement
ALWAYS be done by a qualified technician.
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
NOTE: For this procedure, refer to FIGURE 11.5.
NOTE: For changing or removing/installing the battery boxes, refer to Removing/Installing the
Battery Boxes on page 50.
NOTE: To remove the battery(ies) from the battery box(es), reverse the following procedure.
NOTE: Have the following tools available:
NOTE: The battery lifting strap supplied is for Group 22NF batteries ONLY. Refer to the battery
manufacturer for the proper lifting strap and/or battery tools for U1 battery removal/installation.
ƽ WARNING
ALWAYS use a battery lifting strap when lifting a battery. It is the most convenient
method and assures that the battery acid will not spill. It also helps to prolong the
life of the battery. The battery lifting strap supplied is for Group 22NF batteries
ONLY. Refer to the battery manufacturer for the proper lifting strap and/or battery
tools for U1 battery removal/installation.
DO NOT tip the batteries. Keep the batteries in an upright position.
NOTE: If there is battery acid in the bottom or on the sides of the battery box(es) or battery(ies),
apply baking soda to these areas to neutralize the battery acid. Before reinstalling the new or
existing battery(ies), clean the baking soda from the battery box(es) or battery(ies).
NOTE: When securing battery lifting strap to battery, observe polarity markings located on the
ends of the battery lifting strap, (+) side to POSITIVE (+) battery terminal/post and (-) side to
NEGATIVE (-) battery terminal/post.
TOOL QTY COMMENTS
Battery Lifting Strap 1 See following note.
1/2-inch (6 pt.) Box Wrench 1 Not Supplied
7/16-inch (6pt) Box Wrench 1 Not Supplied
3/8-inch (6pt) Box Wrench 1 Not Supplied
Diagonal Cutters 1 Not Supplied