Filter
Top Products
SECTION 8—SEAT AND BACK
P9000
™
XDT 42 Part No. 1118386
Adjusting the Back Height
NOTE: For this procedure, refer to FIGURE 8.3.
NOTE: Back canes must be adjusted to the same height.
1. Remove the two (2) mounting screws and locknuts that secure the two (2) back canes
to the wheelchair frame.
2. Reposition the back canes to the desired height adjustment position.
3. Reinstall the mounting screws and locknuts that secure the back canes to the
wheelchair frame and securely tighten.
FIGURE 8.3 Adjusting the Back Height
Mounting Screw
Back Cane
Locknut
Wheelchair Frame
Back Height (in inches)
*HOLE#
12 3
HEIGHT 17 18 19
*NOTE: Holes numbered from bottom to top for reference only. (There are no numbers on the
back canes or wheelchair frame.)