Filter
Top Products
7
ADJUSTING THE CONTOUR U
BACK DEPTH (FIGURE 5)
NOTE: There are six (6) depth adjustments avail-
able on the ContourU with a pan back.
NOTE: There are twelve (12) depth adjustments
available on the ContourU with a wood back. Six
(6) mounting positions with the L brackets facing
the front of the wheel chair and six (6) mounting
positions with the L brackets facing the rear of the
wheel chair as shown in FIGURE 5.
NOTE: All four (4) J brackets should be adjusted to
the same depth unless back angle adjustment is
necessary. Refer to
ADJUSTING THE CONTOUR U
SEATING SYSTEM BACK ANGLE in this instruction
sheet after performing this procedure.
1. If necessary, remove the ContourU back.
Refer to
INSTALLING/REMOVING THE
CONTOUR U SEATING SYSTEM BACK
in this instruction sheet.
2. Remove the two (2) mounting screws and
locknuts that secure the J bracket to the L
bracket.
3. Align two (2) mounting holes of the J
bracket with two (2) mounting holes of
the L bracket to acquire the desired
depth as shown in DETAIL A of FIG-
URE 5 .
4. Reinstall the two (2) mounting screws and
locknuts that secure the J bracket to the L
bracket. Securely tighten.
5. Repeat STEPS 3-4 to adjust the remaining
three (3) J and L brackets.
6. Reinstall the ContourU back onto the
wheelchair. Refer to
REMOVING/IN-
STALLING THE CONTOUR U SEATING
SYSTEM BACK in this instruction sheet.
7. Ensure the ContourU back is set to the
desired depth. If necessary repeat STEPS
1-7 until desired depth is achieved.
ADJUSTING THE ON CHAIR MOUNTING KIT MOUNTING
HARDWARE FOR THE CONTOUR U SEATING SYSTEM
BACK
NOTE: Refer to GENERAL and INSTALLATION WARNINGS in the SAFETY SUMMARY in this instruction
sheet.
Locknuts
Mounting
Screws
J Bracket
Mounting Holes
L Bracket
DEPTH ADJUSTMENTS
Pan or Wood Back Additional Positions
For Wood Back Only
DETAIL "A"
FIGURE 5 - ADJUSTING THE
CONTOUR U SEATING SYSTEM
BACK DEPTH