Filter
Top Products
3
Twist
Release
Clamps.
DETAIL "B"
Mark
FRONT OF
WHEELCHAIR
Fixed Release
Clamp
Internal
Threaded
Mounting
Screw
Washer
Mounting
Screw
DETAIL "A"
Upper J Brackets
(Top Edge)
Lower J Brackets
(Bottom Edge)
L Brackets
Back Canes ContourU Back
Mark
Mark
Mark
Internal Threaded
Mounting Screw
Mounting
Screw
Washer
Back Ccane
Lock
Washer
Lock
Washer
FIGURE 1 - INSTALLATION OF THE ON CHAIR MOUNTING KIT BACK
MOUNTING HARDWARE
6. Install the fixed release clamp onto the back cane so that the fixed release clamp is facing
the front of the wheelchair and the bottom edge is aligned with the mark made in STEP 4
as shown in DETAIL "B" of FIGURE 1.
7. Using the mounting screw, washer, lock washer, and internal threaded mounting screw,
secure the fised release clamp to the back cane. Securely tighten.
8. Repeat STEPS 5-6 to install remaining fixed release clamp.
9. Remove the mounting screw, washer, lock washer, and internal threaded mounting screw
from one of the twist release clamps.
10. Install the twist release clamp onto the back cane so that the twist release clamp is facing
the front of the wheelchair and the top edge is aligned with the mark made in STEP 4 as
shown in DETAIL "B" of FIGURE 1.
11. Using the mounting screw, washer, lock washer, and internal threaded mounting screw,
secure the fixed release clamp to the back cane. Securely tighten.
12. Repeat STEPS 8-9 to install remaining twist release clamp.
13. Install the ContourU back onto the chair. Refer to
INSTALLING/REMOVING THE
CONTOUR U SEATING SYSTEM BACK in this instruction sheet.
14. If back depth and or angle adjustments are necessary refer to
ADJUSTING THE
CONTOUR U SEATING SYSTEM BACK in this instruction sheet.