Filter
Top Products
6
INSTALLING/REMOVING THE CONTOUR U SEATING
SYSTEM BACK (FIGURE 4)
Installing
1. Ensure that the twist release clamps are in the OPEN position as shown in DETAIL A of
FIGURE 4.
2. Position the two (2) lower J brackets securely into the two (2) fixed release clamps as
shown in FIGURE 4.
3. Position the upper two (2) J brackets against the back canes just below the two (2) twist
release clamp.
4. Rotate the two (2) twist release clamps to the CLOSED position as shown in DETAIL B
of FIGURE 4.
Removing
1. Rotate the two (2) twist release clamps to the OPEN position as shown in DETAIL B of
FIGURE 4.
2. tilt the top of the ContourU back forward away from the back canes.
3. Puilling UP, remove the ContourU back from the back canes.
Twist Release
Clamps.
(OPEN Position)
Fixed Release
Clamp
J Bracket
Back Canes
ContourU
Back
DETAIL "B"DETAIL "A"
J Bracket
Twist Release Clamps.
(CLOSED Position)
Fixed Release Clamp
J Brackets
Back Canes
ContourU
Back
FIGURE 4 - INSTALLING/REMOVING THE CONTOUR U BACK