Part No. 1090132 Rev F 55 Invacare Scooters
REMOVING/INSTALLING THE FLOOR BASKET (FIGURE 2)
1. To remove, remove the two (2) thumb screws that secure the floor basket in place.
NOTE: The front basket must be installed with angled side facing the front and the vertical side
up against the rear shroud.
2. To install, secure basket to front shroud with two (2) thumb screws. Securely
tighten.
OPTIONS/REPLACEMENT PARTS PROCEDURE 11
OPTIONS/REPLACEMENT PARTS
REMOVING/INSTALLING THE SEAT POSITIONING STRAP
(FIGURE 3)
NOTE: To remove, reverse the following procedure.
INSTALLING
1. Remove the width adjustment knob that is located either underneath or on the back
of the seat frame.
2. Slide width adjustment knob through grommet on seat positioning strap.
3. Reinstall width adjustment knob into seat frame.
4. Repeat STEPS 1-3 for opposite seat positioning strap.
FIGURE 2 - REMOVING/INSTALLING THE FLOOR BASKET
Thumb
Screws
Floor
Basket
Front
Shroud
Front
Shroud
Rear
Shroud
Floor
Basket
SIDE VIEW
OF SCOOTER
Vertical
Side
FIGURE 3 -REMOVING/INSTALLING THE SEAT POSITIONING STRAP
Seat Positioning
Strap
Seat Frame
Grommet
Width Adjustment
Knob