Filter
Top Products
Invacare Scooters 46 Part No. 1090132 Rev F
PROCEDURE 9 SHROUD/WHEELS
This Procedure Includes the Following:
Removing/Installing the Rear Shroud
Replacing Foam Filled Tires Onto Wheel Rims
Removing/Installing the Rear Wheels
Removing/Installing the Front Wheel
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure
that all attaching hardware is tightened securely - otherwise, injury or
damage may result.
REMOVING/INSTALLING THE REAR SHROUD (FIGURE 1)
REMOVING
NOTE: To install rear shroud, reverse this procedure.
1. Remove the seat. Refer to REMOVING/INSTALLING THE SEAT in PROCEDURE 5
of this manual.
CAUTION
SLOWLY remove rear shroud on
PANTHER MX-4. Wiring harness for
taillights is still connected to the bat-
tery harness. Otherwise, damage may
result.
2. PANTHER MX-4 MODELS -
Slowly remove the rear shroud and
place on floor close to the scooter.
Disconnect taillight wiring harness
from battery wiring harness.
3. ALL MODELS - Lift the rear shroud
off of the frame post.
REPLACING FOAM FILLED
TIRES ONTO WHEEL RIMS
WARNING
This procedure MUST be per-
formed by a qualified technician.
NOTE: During initial use of scooter, user may
experience flat spot on wheels. Flat spot will
vanish with continuous use of scooter.
TILLER ADJUSTMENT
FIGURE 1 - REMOVING/
INSTALLING THE REAR SHROUD
Rear Shroud
Frame
Post
PANTHER MX-4
Rear Shroud
Taillight
Wiring
Harnes
Battery
Wiring
Harnes
ALL MODELS