Filter
Top Products
SECTION 12—BATTERIES
300 and 400 58 Part No. 1118395
CHARGING THE BATTERIES
ƽ WARNING
NEVER attempt to recharge the batteries by attaching cables directly to the
battery terminals or clamps.
DO NOT attempt to recharge the batteries and operate the powered scooter at
the same time.
ࣼ CAUTION
New batteries MUST be fully charged prior to initial use of the powered scooter.
Always charge new batteries before initial use or battery life will be reduced.
As a general rule, you should recharge your batteries as frequently as possible to
assure the longest possible life and to minimize required charging time. Plan to
recharge them when you do not anticipate using the powered scooter.
The range per battery charge using recommended batteries should be approximately five
(5) to nine (9) hours of typical operation. Extensive use on inclines may substantially
reduce per charge mileage.
ƽ WARNING
If the circuit breaker trips repeatedly, IMMEDIATELY unplug charger and contact
dealer or a qualified technician.
ON-BOARD BATTERY CHARGER
NOTE: The powered scooter is designed with an electrical lockout to prevent it from being driven
while the charger is plugged into an outlet.
NOTE: For this procedure, refer to FIGURE 12.6.
1. Plug AC power cord into on-board battery charger port located to the rear shroud.
2. Plug AC power cord into 110-volt wall outlet.
3. Refer to Battery Charger Operation - Charger Indicator Light on Tiller
on page 59.