Filter
Top Products
SECTION 6—OPERATION OF THE POWERED SCOOTER
300 and 400 32 Part No. 1118395
FIGURE 6.3 - BRAKE RELEASE LEVER
RESETTING THE CIRCUIT BREAKER
ƽ WARNING
NEVER defeat or bypass the circuit breaker. ONLY replace with a circuit breaker of
the same rating.
NOTE: Key must be removed from ignition before resetting circuit breaker.
NOTE: For this procedure, refer to FIGURE 6.4.
1. Remove seat. Refer to Removing/Installing the Seat on page 34.
2. Remove rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.
3. To reset, press circuit breaker button located on the controller tray.
4. Reverse STEPS 1 and 2 to reassemble the powered scooter.
FIGURE 6.4 - RESETTING THE CIRCUIT BREAKER
Controller Tray
Brake Release Lever
Transaxle
NOTE: Brake Release Lever
on 300 shown. Brake
Release Lever on 400
operates the same way.
DISENGAGED
(PULL LEVER
OUT)
ENGAGED
(PUSH LEVER IN)
Circuit
Breaker
Button
Controller Tray
DETAIL “B” - 400DETAIL “A” - 300
Circuit
Breaker
Button
Controller Tray