Filter
Top Products
SECTION 6—OPERATION OF THE POWERED SCOOTER
300 and 400 30 Part No. 1118395
OPERATING THE SCOOTER
ƽ WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
DO NOT make sharp turns in the forward or reverse direction at excessive speed.
Failure to observe the warning can cause the scooter to tip over and may result in
injury to user and/ or damage to the product.
To determine and establish your particular safety limits, practice bending, reaching
and transferring activities in several combinations in the presence of a qualified
healthcare professional BEFORE attempting active use of the powered scooter.
Ensure seat is properly locked before attempting transfer into or out of the
powered scooter. Attempting unsafe transfers may cause a fall from the powered
scooter resulting in bodily injury.
For individuals with balance problems, practice transferring activities WITH AN
ASSISTANT in the presence of a qualified healthcare professional. DO NOT
attempt to transfer into or out of the powered scooter without assistance.
1. Before operation of the powered scooter, review Control Panel on page 27.
2. Install and charge batteries. Refer to Removing/Installing the Batteries on 300 on
page 50, Removing/Installing the Batteries on 400 on page 53 and Charging the
Batteries on page 58.
3. Transferring to and from the seat can be accomplished in one (1) of two (2) ways:
A. Flipping UP the armrest makes entering/exiting easier.
B. Rotate seat to the direction of transfer. Refer to 90° Seat Swivel Adjustment
on
page 37.
4. Once the seat is locked in the forward-facing position and both armrests are in the
DOWN position, adjust the tiller to a comfortable angle. Refer to Adjusting the Tiller
Angle on page 43.
5. Adjust speed control knob to the appropriate setting.
NOTE: For driving indoors or on uneven terrain, a slower speed is recommended. For soft terrain
or steep inclines (no greater than 8°), a faster speed may be necessary.
6. Insert the key into the ignition and turn it to the ON position.
ƽ WARNING
ALWAYS depress the throttle control lever gradually. This will ensure smooth safe
starts.