Support User Manuals

Invacare GET-U-UP LIFT Mobility Aid User Manual

Open as PDF

of 32

INSTALLATION

Part No. 1148115 11 Get-U-Up

™

Lift

NOTE:Besurethattheshoulderboltiscompletelythroughtheholesofthemastassemblyandhorn

assembly,andtheyarenotridingontheshoulderofthebolt.Thenylonwashersmustsitbetween

thehornbushingandhornmountinglugs.

CAUTION

When assembled, the horn and mast assemblies MUST pivot easily.

10. Tightenthe shoulderboltandlocknut.Thelocknutandshoulderboltcanbetightened

completely.

NOTE:Thehornassemblywillpivoteasilyifthemountinghardwareisalignedproperlywhenthe

hornassemblyissecuredtothemast.Tocheckforcorrectalignmentofthehardware,usetheAllen

wrenchprovidedandturntheshoulderboltbyhand(itshouldrotatewithoutalotofforcebeing

applied).Ifexcessiveforceisnecessary,theshoulderboltisNOTalignedproperly.Disassembleand

repeatassemblyprocedur esuntilproperalignmentisobtained.

11. Tocheckfortightnessofthelocknutandshoulderbolt:

A. Raisethehornassembly.

B. Pushthecontrolhandleawayfromthepumpassembly.

C. Ifthehornassemblypivotseasily,thelocknutandshoulderboltarenottootight.

D. Ifthehornassemblydoesnotpivoteasilyordoesnotpivotatall,thelocknutand

boltarenotalignedproperly.Repeatssteps7to11.

12. Removetheshoulderboltandlocknutfromthecylinderlugsonthehornassembly.

13. Aligntheholesofthecylinderlugsandthecylinderrod.

14. Inserttheshoulderboltcompletelythroughtheholes.

15. Tightenthelocknutandshoulderbolt.

previous next