Support User Manuals

Invacare GET-U-UP LIFT Mobility Aid User Manual

Open as PDF

of 32

INSTALLATION

Get-U-Up

™

Lift 10 Part No. 1148115

SECTION 2— INSTALLATION

Assembling the Base, Mast and Horn Assembly

ƽ WARNING

The mast may be removed from the base for storage or transporting. Each time the

mast is removed and returned to the socket of the base, the mast MUST be locked

into the socket of the base assembly.

NOTE:Forthisprocedure,refertoFIGURE 2.1andFIGURE 2.2onpage12.

1. Unpackthecomponentsfromtheshippingcartons.

2. Removethelockingscrewfromthebottomofthebase.

3. Matchthenotchatthebottomofthemastassemblywiththetabsinsidethesocketof

thebaseassembly.

4. Insertthemastassemblyintothesocketandontothetabs.

5. Attempttoturnthemastassembly.

NOTE:Ifthemastdoesnotturn,themastiscenteredandlockedinplace.

6. Insertthelockingscrewintothebottomofthebaseandtightensecurely.

FIGURE 2.1 Assembling Mast to Base

7. Removetheshoulderbolt,steelwashers,nylonwashers,and

locknutfromthehorn

mountinglugsatthetopofthemastassembly.

8. Aligntheholesofthehornmountinglugsandthehornbushing.

9. Inserttheshoulderboltcompletelythroughthe holesofthehornmountinglugs,horn

bushing,nylonwashersandsteelwashers.RefertoFIGURE 2.2onpage12.

Mast

Notch

Locking

Screw

Socket

Tab

previous next