Filter
Top Products
32
Adjusting Gear Shift Push Button (FIGURE 7)
WARNING
Incorrect adjustment of gear shift push button
may reult in a failure of the coaster brake, pos-
sibly causing injury and or damage.
1. Loosen, but do not remove the allen set screw in
the middle of the gear shift push button.
2. Turn in the gear shift push button approximately two
(2) revolutions.
3. Push the gear shift push button IN.
4. Move the hand crank slightly until the switch posi-
tion engages audibly.
5. Turn the gear shift push button until it is flush with
the hand crank.
NOTE: Make sure there is some play underneath the
button.
6. Securely tighten the allen set screw in the middle
of the gear shift push button.
FIGURE 7 - MOUNTAIN DRIVE OPTION -
ADJUSTING GEAR SHIFT PUSH BUTTON
Gear Shift
Push Button
Allen Wrench
Hand Crank
O
P
E
R
A
T
I
O
N
OPERATIONPROCEDURE 12
FIGURE 6 - MOUNTAIN DRIVE OPTION -
BEARING PLAY ADJUSTMENT
Hand
Crank
Self-Locking Nut
Bearing Play Adjustment (FIGURE 6)
NOTE: Refer to the SAFETY INSPECTION CHECKLIST
to determine how often bearing play adjustment is nec-
essary.
NOTE: This adjustment is required only if there is some
play in the hand crank in a SIDE TO SIDE motion.
NOTE: There will be some play in a forward/rearward
motion.
1. Slightly tighten self-locking nut on the left side (sitting
in the handcycle) of the hand crank. DO NOT over-
tighten.
NOTE: Overtightening the self-locking nut will cause the
gears to engage improperly after shifting.