Filter
Top Products
SECTION 11—WHEELS AND CASTERS
Zoom
™
300 and Zoom
™
400 48 Part No. 1118395
REMOVING/INSTALLING THE CASTER
ASSEMBLIES
NOTE: For this procedure, refer to FIGURE 11.3.
REMOVING
1. Apply a wrench to the hex nut on the caster assembly.
2. Turn the hex nut COUNTER-CLOCKWISE to loosen and remove the caster wheel.
3. If necessary, repeat STEPS 1-2 to remove the other caster.
INSTALLING
1. Insert the new caster wheel into the caster housing and turn the hex nut CLOCKWISE
to securely tighten the caster wheel in place.
FIGURE 11.3 - REMOVING/INSTALLING THE CASTER ASSEMBLIES
Swingarm Assembly
Caster Housing
Hex Nut
Caster