Filter
Top Products
SECTION 7—SEAT
Part No. 1118395 35 Zoom
™
300 and Zoom
™
400
REMOVING/INSTALLING THE SEAT POST
ƽ WARNING
Ensure that the seat post mounting screw is properly engaged and locked. Other-
wise, injury and/or damage may result.
NOTE: Take note of position and orientation of the seat post and seat post mounting screw before
removing.
NOTE: The seat post has three (3) height settings. If a change in seat height is desired refer to
adjusting seat height in this section of the manual.
NOTE: For this procedure, refer to FIGURE 7.2.
REMOVING
1. If necessary, remove the seat. Refer to Removing/Installing the Seat on page 34.
2. Remove the mounting screw, two (2) washers and locknut securing the seat post to the
frame post (FIGURE 7.2).
3. Lift seat post UP and remove from frame post.
INSTALLING
1. Insert the seat post into the frame post and align the frame post mounting hole with
the desired seat post mounting hole. Refer to FIGURE 7.2.
2. Insert mounting screw through both the frame post and the seat post. Install the two
(2) washers and locknut onto mounting screw and securely tighten.
3. If necessary, install the seat. Refer to Removing/Installing the Seat on page 34.
FIGURE 7.2 - REMOVING/INSTALLING THE SEAT POST
Seat Post
Seat Post
Mounting Holes
Washer
Washer
Locknut
Mounting Screw
Frame Post
Mounting Screw
NOTE: Seat post on Zoom 300 shown. Seat
post on Zoom 400 installs the same way.