Filter
Top Products
SECTION 7—BACK ADJUSTMENTS
2G Tarsys®Powered Seating System 94 Part No 1114842
Removing/Installing/Adjusting Chest Positioning Strap
NOTE: For this procedure, refer to FIGURE 7.11.
NOTE: This procedure applies to systems with slotted canes only.
Removing
1. Note the position of the existing chest positioning strap.
2. Loosen, but DO NOT remove, the socket screw that secures the existing chest
positioning strap to the back slide.
3. Slide the existing chest positioning strap off the back slide.
Installing
1. If necessary, loosely install the T-nut and hex screw onto the new chest positioning
strap.
2. Position the new/existing chest positioning strap and line up the T-nuts with the slots
in the back slide.
3. Slide new/existing chest positioning strap to the position noted in STEP 1 in Removing
on page 93.
4. Tighten the two socket screws that secure the new/existing chest positioning strap to
the back slide securely.
Adjusting Height
1. Loosen, but DO NOT remove, the two
socket screws that secure the chest
positioning strap to the back slide.
2. Slide the chest positioning strap to the
desired position.
3. Tighten the two socket screws that
secure the chest positioning strap to the
back slide securely.
FIGURE 7.11 Removing/Installing/Adjusting
Chest Positioning Strap
Chest
Positioning Strap
Back
Slide
Washer
T-Nut
Socket Screw