Filter
Top Products
SECTION 5—INTERFACE HARDWARE
Part No 1114842 41 2G Tarsys®Powered Seating System
Removing/Installing the Rear Pivot Assembly
Tilt Only and Tilt/Recline Systems
NOTE: For this procedure, refer to FIGURE 5.2 on page 43.
Removing
1. Remove the seat assembly. Refer to Removing/Installing the Seat
on page 75.
TABLE 14 - 2GT and 2GTR Systems WITH Center Mount Footrests AND
Ventilator-Ready Battery Tray
SEAT
DEPTH
MOUNTING POSITION
21-INCH
22-INCH
NOTE: Torque the hardware as listed below:
• Hex screws or socket screws (securing the rear pivot): 75 in-lbs ± 20%.
• Hex screws (securing the front pivot assembly and front of seat bracket) and shoulder
screw (securing the tilt actuator): 13 ft-lbs ± 20%.
Hex Screw
Locknut
Locknuts
(STEP 9)
Hex Screws
Seat Bracket
Lower Interface
Bracket
Front Pivot
Assembly
Shoulder Bolt
and Locknut
Tilt Actuator
Socket Screw
Linear Guide*
*NOTE: Linear guides are exploded for clarity. DO NOT disconnect the upper
and lower portions of the linear guides. The linear guide cannot be reassembled.
Shim
Locknuts
Washer
Rear Pivot Assembly