Filter
Top Products
SECTION 7—BACK ADJUSTMENTS
Part No 1114842 83 2G Tarsys®Powered Seating System
FIGURE 7.2 Removing/Installing the Curved Links - Tilt Only Systems
Recline Only and Tilt/Recline Systems
NOTE: For this procedure, refer to FIGURE 7.3 on page 84.
Removing
ƽ WARNING
Perform this procedure on one side of the wheelchair at a time. Otherwise the back
will be completely disconnected from the seat and injury or damage may occur.
1. Remove the side shroud. Refer to Removing/Installing Side Shrouds on page 100.
2. Remove the short socket screw, nylon washer, flat washer and locknut securing the top
of the curved link to the back cane.
3. Remove the long socket screw, nylon washer and locknut securing the rear of the slide
block to the connecting bracket.
4. Remove the curved link from the wheelchair.
Nylon
Washer
Locknuts
Connecting
Bracket
Small Socket Screw
Curved Link
Back Cane
Large Socket Screw
Slide
Block