Filter
Top Products
SECTION 7—BACK ADJUSTMENTS
2G Tarsys®Powered Seating System 90 Part No 1114842
Removing/Installing Back Slide Assembly
NOTE: For this procedure, refer to FIGURE 7.8 on page 91.
Removing
1. Remove the back pan. Refer to Removing/Installing Back Pan on page 85.
2. Perform one of the following:
• Tilt-Only Systems - Remove the two shoulder screws and washers that secure the
two existing back slides to the existing back canes from the BOTTOM mounting
hole.
• Tilt/Recline and Recline-Only Systems - Remove the two shoulder screws and
washers that secure the two existing back slides to existing back canes from the
TOP mounting hole.
3. Slide the existing back slide assembly up and off the existing back canes.
NOTE: There are plastic sleeves positioned between the back slides and the back canes. These may
fall out when back slide assembly is removed.
Installing
1. Install the two new/existing plastic sleeves on the new/existing back canes.
2. Slide the new/existing back/back slide assembly onto the two new/existing back canes.
3. Line up the mounting holes in the new/existing back/back slide assembly, two plastic
sleeves and new/existing back canes.
4. Perform one of the following:
• Tilt-Only Systems - Install the two shoulder screws that secure the two
new/existing back slides and plastic sleeves to the new/existing back canes on the
BOTTOM mounting hole. Tighten securely.
• Tilt/Recline and Recline-Only Systems - Install the two shoulder screws that secure
the two new/existing back slides and plastic sleeves to the new/existing back canes
on the TOP mounting hole. Tighten securely.
5. Perform one or more of the following:
• Replace the back canes. Refer to Removing/Installing Back Canes on page 89.
• Install the back pan. Refer to Removing/Installing Back Pan
on page 85.