![](http://pdfasset.owneriq.net/6/01/601a7e6a-aa4e-4457-9dc0-0e9d1164943c/601a7e6a-aa4e-4457-9dc0-0e9d1164943c-bg84.png)
SECTION 13—TILT AND RECLINE
2G Tarsys®Powered Seating System 132 Part No 1114842
FIGURE 13.4 Removing/Installing the Tilt Actuator
Removing/Installing the VSR Actuator
NOTE: For this procedure, refer to FIGURE 13.5.
Removing
1. Remove the VSR actuator shroud. Refer
to Removing/Installing VSR Shroud on
page 100.
2. Disconnect the VSR actuator connector
from the TRCM or TAC VSR actuator
connectors (Not shown).
3. Remove the hex bolt and locknut that
secure the existing VSR actuator to the
spreader bar.
NOTE: When the spreader bar is disconnected
from the VSR actuator, the back pan ASM may
slide out of position.
4. Remove the hex bolt, washers and
locknut that secure the existing VSR
actuator to the actuator mounting
bracket.
FIGURE 13.5 Removing/Installing the VSR
Actuator
Rear Pivot
Assembly
Locknut
Shoulder
Bolt
Rear of Tilt
Actuator
Shoulder
Bolt
Front of Tilt
Actuator
Tilt Actuator
Locknut
DETAIL “A”
DETAIL “B”
Front Pivot
Assembly
Spacers
Locknut
Spreader Bar
VSR Actuator Bracket
Locknut
Washers
Hex Bolt
Hex Bolt
VSR
Actuator
Connector
VSR
Actuator