Filter
Top Products
SECTION 12—SCOOTER ACCESSORIES
Part No. 1125053 49 Zoom
220
Installing/Removing/Using the Walker Holder
ƽ INSTALLATION WARNINGS
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely.
The installation of the walker holder onto the back of the scooter seat significantly
increases the length of the scooter. When turning the scooter or swiveling the
scooter seat, it is important to take note of this increased length - otherwise, injury
and/or damage to the surrounding property may result.
Installing/Removing the Walker Holder
NOTE: Reverse this procedure to remove the walker holder.
NOTE: For this procedure, refer to FIGURE 12.3.
1. If necessary, loosen but DO NOT
remove the mounting knob.
2. Install the walker holder into the
accessory tube.
3. Thread the mounting knob into the
welded nut on the accessory tube.
Securely tighten.
FIGURE 12.3 Installing/Removing the
Walker Holder
Using the Walker Holder
NOTE: For this procedure, refer to FIGURE 12.4.
1. Fold walker. Refer to walker
instructions.
NOTE: Walker MUST be folded before using
walker holder.
2. Hang folded walker on walker holder
hooks.
3. Secure walker with hook and loop
straps.
FIGURE 12.4 Using the Walker Holder
Seat
Accessory
Tube
Walker Holder
Seat
Mounting
Knob
Hook
Hook and
Loop Strap