Filter
Top Products
SECTION 10—BATTERIES
Zoom
220 42 Part No. 1125053
Removing/Installing the Batteries
NOTE: For this procedure, refer to FIGURE 10.3.
Removing
1. Remove the seat. Refer to Removing/Installing/Adjusting the Padded Seat on page 29
or Removing/Installing the Deluxe Seat on page 31.
2. Remove the battery box from the scooter. Refer to Removing/Installing the Battery Box
on page 41.
3. Remove the nine (9) mounting screws that secure the battery box top to the battery box
(Detail “A” of FIGURE 10.3).
4. Disconnect the wiring harness from the batteries by holding the connectors and
pulling them in the following order (Detail “B” of FIGURE 10.3):
A. NEGATIVE (-) BLACK battery cable from the NEGATIVE (-) battery terminal on
the left battery.
B. POSITIVE (+) RED battery cable from the POSITIVE (+) battery terminal on the
right battery.
C. WHITE battery cable (Jumper) from the POSITIVE (+) battery terminal on the left
battery and the NEGATIVE (-) battery terminal on the right battery.
5. Remove the batteries from battery box by lifting the batteries out.
Installing
1. Install the two (2) new batteries into the battery box.
2. Connect the wiring harness to the batteries in the following order (Detail “B” of
FIGURE 10.3):
A. NEGATIVE (-) BLACK battery cable to the NEGATIVE (-) battery terminal on the
left battery.
B. POSITIVE (+) RED battery cable to the POSITIVE (+) battery terminal on the right
battery.
C. WHITE battery cable (Jumper) to the POSITIVE (+) battery terminal on the left
battery and the NEGATIVE (-) battery terminal on the right battery.
3. Replace the top of the battery box and secure with the nine (9) mounting screws
(Detail “A” of FIGURE 10.3). Securely tighten.
4. Reinstall the battery box on to the scooter frame. Refer to Removing/Installing the
Battery Box on page 41.
5. Reinstall the seat. Refer to Removing/Installing/Adjusting the Padded Seat on page 29
or Removing/Installing the Deluxe Seat
on page 31.