Filter
Top Products
13 TROUBLESHOOTING
Part No. 1163141
57 Invacare® Leo™ Scooter
13.2 Service Indicator Error Codes
For the following table, refer to FIGURE6.1 on page 26.
FLASH DESCRIPTION SCOOTER STATUS MEANING
1 Battery Low Scooter continues to drive The batteries are running low.
• Recharge the batteries.
2 Low Battery Fault Scooter stops driving The batteries have run out of charge.
• Recharge the batteries.
3 High Battery Fault Scooter stops driving Battery voltage is too high. This may occur if overcharged &/or traveling down a long slope.
• If traveling down a slope, reduce your speed to minimize the amount of regenerative charging.
• Turn the scooter off and on again.
• If the battery charger is connected, disconnect it from the scooter.
• Check the battery and associated connections and wiring.
4 Current Limit Time-
out
Scooter stops driving The motor has been exceeding its maximum current rating for too long. This may be due to a faulty
motor.
• Check the motor and associated connections and wiring. Contact your Invacare dealer.
• Turn the scooter off, leave for a few minutes and turn back on again.
5 Park Brake Fault Scooter stops driving Either a park brake release switch is active or the park brake is faulty.
• Check the park brake and associated connections and wiring.
• Ensure any associated switches are in their correct positions.
• Contact your Invacare Dealer.
6 Throttle OONAPU Scooter stops driving The Throttle is out of neutral when turning the controller on.
• Ensure the throttle is in neutral when turning the controller on.
• The Throttle may require re-calibration. Contact your Invacare Dealer.
7 Speed Pot Fault Scooter stops driving The throttle, speed limit pot, SRW or their associated wiring may be faulty.
• Check the throttle and speed pot and associated connections and wiring. Contact your Invacare
Dealer.
8 Motor Voltage Fault Scooter stops driving The motor or its associated wiring is faulty.
• Check the motor and associated connections and wiring. Contact your Invacare Dealer.
9 Other error Scooter stops driving The controller may have an internal fault.
• Check all connections & wiring. Contact your Invacare Dealer.
10 Push/Rollaway Fault Scooter stops driving The scooter has exceeded the Push or Rollaway speed limits.
• Turn the scooter off and then on again.