Filter
Top Products
9 WHEELS AND CASTERS
Invacare® Leo™ Scooter
42 Part No. 1163141
9 Wheels and Casters
9.1 Removing/Installing the Drive Wheels
Removing
1. Turn power off and remove the key from the ignition.
2. Remove the seat. Refer to Removing/Installing the Seat
on page 33.
3. Place the rear frame assembly (not shown) up on blocks so that the
drive wheels are off the ground.
4. Remove the cap, locknut and small washer from the threaded end
of the drive shaft.
5. Remove the existing drive wheel assembly from the drive shaft.
6. Remove the large washer from the drive shaft.
7. Remove keystock from drive shaft. Set aside.
8. If necessary, repeat STEPS 1-7 to remove other drive wheel.
FIGURE 9.1 Removing/Installing the Drive Wheels
ƽ
WARNING
After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely -
otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power Off and remove key from ignition.
For this procedure, refer to FIGURE 9.1 on page 42.
This procedure applies to the rear wheels of the four wheel and three wheel models.
Use a wheel puller if necessary to remove the
wheel from the drive shaft.
Keystock
Threaded End
Small Washer
Drive Wheel
Cap
Large Washer
Locknut
Drive Shaft