Filter
Top Products
11 TRANSPORTING
Invacare® Leo™ Scooter
52 Part No. 1163141
11 Transporting
11.1 Transporting the Scooter
Disassembling
1. Turn power off and remove the key from the ignition.
2. Remove the basket.
3. Remove the seat. Refer to Removing/Installing the Seat
on page 33.
4. Remove the batteries. Refer to Removing/Installing the Batteries on
page 48.
5. Disconnect the main wiring harness connector.
6. Hold the seat post with one hand.
7. With the other hand, push the release lever to the rear of the
scooter.
8. Lift the seat post to separate the front frame assembly from the
rear frame assembly.
9. Fold tiller down to lowest locked position. Refer to Adjusting the
Tiller Angle on page 41.
FIGURE 11.1 Transporting the Scooter
ƽ
WARNING
After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely -
otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power off and remove key from ignition.
DO NOT lift the scooter by the rear shroud - otherwise damage to the scooter may occur.
For this procedure, refer to FIGURE 11.1 on page 52.
Release
Lever
Main Wiring
Harness
Connector
Rear of
Scooter
Front of Scooter
Seat
Post
Front
Frame
Assembly
Rear
Frame
Assembly
Front Frame
Curved
Bracket On
Rear Frame
Post