Filter
Top Products
2 Change the password for 5654A09A from xxxxxxxx to a valid password, in
accordance with your security guidelines.
3 If you intend to use an SFS directory in place of the 191 minidisk for the
5654A09A user ID, the IPL statement must include the values "PARM
FILEPOOL poolid:" (poolid is the name of the SFS Filepool where 5654A09A
is enrolled). For example:
IPL CMS PARM FILEPOOL NEWPOOL:
This will cause CMS to automatically access 5654A09A's top directory as file
mode A.
4 Include MDISK statements for the test BUILD disk (default virtual address
4E2) and for the production BUILD disk (default virtual address of 491) in the
directory definition for 5654A09A. Refer to Figure 8 on page 11 to obtain the
minidisk requirements for these two disks.
Note: These minidisks must be formatted before installing Tivoli ADSM for
VM.
5 Add the 5654A09A directory definition to the system directory.
Note: Updates to the CP system directory can be done only from authorized
user IDs. If you or any of your user IDs do not have the proper authority,
then seek help from the person who has the proper authority.
6 Place the new directory definition on-line using VM/Directory Maintenance
(DIRMAINT) or an equivalent CP directory maintenance method.
7 An SFS install will also require the following steps:
a Determine the number of 4K blocks that are required for SFS directories
by adding up the 4K blocks required for each SFS directory you plan to
use.
If you intend to use all of the default Tivoli ADSM for VM SFS
directories, the 4K block requirements for each are summarized in
Figure 8 on page 11.
This information will be used when enrolling the 5654A09A to the
VMSYS filepool.
b Enroll user 5654A09A in the VMSYS filepool using the ENROLL USER
command:
ENROLL USER 5654A09A VMSYS: (BLOCKS blocks
where blocks is the number of 4K blocks that you calculated in the
previous step.
Installation Instructions 21