Filter
Top Products
– 5 –
ASSEMBLING THE SLIDING GLASS DOORS
1. Position the top of either door in the top
inner track (Fig. 3).
2. Place the bottom of the first door so it
straddles the bottom inner guide. Slide
door so handle is away from middle.
3. Position the top of the second door in the
top outer track.
4. Place the bottom of the second door so
it straddles the bottom outer guide.
ASSEMBLE THE WIRE SHELF
• Place the welded wire shelf into the
guides so it straddles the well opening.
ASSEMBLE THE KNOB ON THE MAIN POWER SWITCH
1. Remove the Phillips head screw from the switch knob.
2. Remove the white nylon insert from the switch knob.
3. Place the white nylon insert on the post of the Main Power Switch so the slots fit.
4. Install the switch knob over the white nylon insert so the slots fit; the knob should point to
the off position.
5. Retighten the Phillips head screw.
ASSEMBLE THE LOWER PANEL ON THE OPERATOR SIDE
1. After the display case is in its final position, install the lower panel on the operator side of
the case. Use the 6 or 8 screws provided in the threaded holes.
2. Remove the top screws; back out the lower screws.
3. Fit the lower panel up from the bottom so the slots on the bottom of the panel surround the
lower screw heads.
4. Use a nut driver to insert the upper screws through the holes in the panel until all screws are
secured to the main frame of the display case.
ASSEMBLE THE LIGHT BULBS
• Assemble the long life light bulbs into the sockets in the top of the display case.
ASSEMBLING THE CUTTING BOARD
• When ordered, assemble the accessory cutting board on the display case using the
instructions provided with it.
Fig. 3
INNER GUIDE
OUTER GUIDE
INNER TRACK