Filter
Top Products
– 4 –
Fig. 1
SLOT
INSTALLATION
Before installing, check the electrical service to make sure it agrees with the specifications on the
machine data plate, located on the operator side of the display case.
UNPACKING
Immediately after unpacking the display case, check for possible shipping damage. If the display
case is found to be damaged, save the packaging material and contact the carrier within 15 days
of delivery.
Remove all vinyl paper from the stainless steel surfaces. Remove any tape from the glass and
steel surfaces.
On all models, the following parts are shipped inside the display case to be assembled at the time
of installation: Two Side Glass Panels, one or two Lower Front Glass Panels, two or four Sliding
Doors, one Wire Shelf, one Knob for the Main Power Switch, one Lower Panel, four to eight Light
Bulbs. When the accessory Cutting Board is ordered, it is shipped in its own box.
ASSEMBLING THE SIDE GLASS PANELS & LOWER FRONT GLASS PANEL
CAUTION: Handle glass panels with care to avoid breakage. The side and center glass
panels are tempered safety glass. If the edges of the glass panels scrape against stainless
steel, concrete or other hard surfaces, breakage may occur.
Install the Side Glass Panels
1. Raise the front glass. The glass stays up
by itself.
2. Position the side glass panel in the slot
on the LEFT side of the case (Fig. 1).
3. Carefully slide the side glass panel
toward the rear (operator side) of the
display case so it is completely seated
and held in place by the angled slot in
the rear of the case.
4. Repeat steps 2 and 3 for the RIGHT side
of the case.
5. Lower the front glass.
Install the Lower Front Glass Panel
• Slide the lower front glass panel(s) down
into the slots on the customer side.
Fig. 2
SLOT
LOWER FRONT
GLASS PANEL