Filter
Top Products
Dispensing and Spraying
14 3A0590G
10. Engage the trigger lock.
11. Close solvent inlet valve (C).
12. Remove the gun from the hose. See gun manual to
further clean the gun.
Dispensing and Spraying
1. Close the solvent inlet valve (C) and A side solvent
valve (T) if equipped.
2. Open the dual shutoff handle (E).
3. Turn on sprayer. See sprayer operation manual.
4. Disengage the trigger lock.
5. Hold the metal part of the gun firmly to a grounded
metal pail with a lid to avoid splashing. Trigger the
gun until mixed coating material is evident and
purge solvent is gone.
6. Proceed spraying.
NOTICE
To prevent damage to the valve balls and seats,
always fully open or fully close the dual shutoff han-
dle. Also increase the fluid pressure after opening
the ball valves to allow valves to last longer.
ti1949a
ti1950a
ti1953a