Filter
Top Products
support.dell.com Installing Your Stand-Alone Storage System 3-1
&+$37(5
,QVWDOOLQ J<RXU 6WDQG$ORQH
6WRUDJH6\VWHP
This chapter describes how to install the Dell PowerVault 201S and 211S storage sys-
tems in a free-standing, vertical configuration, also called a tower.
6HWWLQ J8SD6WDQG$OR QH6WR UDJ H6\VWHP
A stand-alone installation kit is available from Dell for installing a rack storage system
in a stand-alone unit. One stand-alone unit is required for each rack storage system
installed.
If you have an upgrade kit, perform all the steps. If you ordered your PowerVault 201S
or 211S from Dell, perform the steps described in "Attaching Stabilizers to the Stand-
Alone Chassis," found later in this chapter; the other steps have already been
completed.
5DFN,QVWDOODWLRQ5HVWULFWLRQV
The stand-alone kit is intended to be installed by a certified service technician.
6WDQG$ORQH.LW&RQWHQWV
The stand-alone kit includes the following items:
One stand-alone chassis
Two hat flanges (top and bottom)
Two stabilizers
Eight 6-32 x 1/2-inch Phillips pan-head screws
Four 6-32 x 1/2-inch Phillips hex-head screws
Eight 6-32 x 1/4-inch Phillips flat-head screws
NOTE: Some parts may be preinstalled.