Filter
Top Products
DR
®
TRIMMER/MOWER
™
Safety & Operating Instructions 31
Figure 28
To decrease the tension on the belt:
1. Repeat the steps for increasing the
tension on the belt, but instead
loosen the lower nut and tighten
the upper nut.
Note: To check your adjustment,
measure the spring with the bail bar
disengaged. Then measure it with the
bail bar engaged. There should be a ¼″
extension in the spring when the bail
bar is engaged (Figure 28). Adjust the
nuts on the bracket as needed to get
the correct measurements.
Removing and Replacing the Side Shield
Tools needed: You will need the tools listed below.
■
1
⁄8″ wrench or socket
■
5
⁄32″ Allen wrench
1. Remove the six mounting bolts and discard the old shield.
2. Mount the new shield, insert the bolts and tighten them.
WARNING! Before performing any maintenance procedure, stop the
engine and disconnect the spark plug wire.
Important!
You should never operate the trimmer without the side shield
in place. If the side shield becomes damaged, replace it immediately.