Filter
Top Products
DR
®
TRIMMER/MOWER
™
Safety & Operating Instructions 27
Figure 21
Reassembling the Mow-Ball
Support Assembly
1. Position the backup plate with
the curve facing up. (Figure
21)
2. Stack the line plates on top of
one another with the bumps
on the bottom locking into the
grooves on top of each plate.
3. Place the head of the Mow-
Ball
bolt so it is sitting in the
groove at the bottom of the
Mow-Ball
Support.
4. Hold the bolt head in place
with your finger and turn the
Mow-Ball
Support assembly
clockwise until it is finger tight.
WARNING! Before performing any maintenance procedure, stop the
engine and disconnect the spark plug wire.
Important: Improper
installation can cause
damage to your
machine’s bearings.
Following these
directions carefully will
protect your machine
from damage.
Reassemble the
components in the
order shown in Figure
21