Filter
Top Products
28 DR
®
TRIMMER/MOWER
™
Safety & Operating Instructions
Figure 22
Figure 23
Removing the Stone Guard Flap
Note: We turned the trimmer on its side to take the photos in this section. To do so, we
removed gas and oil from the machine.
You can access the underside of the
trimmer without having to drain gas and oil
by tilting back on its handlebar.
Tools needed: You will need a
3
⁄8″ wrench
or socket to perform these steps.
1. Remove the screws on either side of
the stone guard and drop it from the
frame (Figure 22).
Tip: Keep the screws together with the
stone guard.
Removing and Replacing the Bottom Shield
Note: You do not need to remove the side shield or any of its hardware when removing the
bottom shield.
Tools needed: You will need a
7
⁄16″ wrench or socket to perform these steps.
1. Remove the Mow-Ball
Support Assembly. See the Removing and Reinstalling the Mow-
Ball™ Assembly section on page 26.
2. Remove the stone guard flap. See “Removing the Stone Guard Flap” on page 28.
3. Remove the two mounting bolts and
washers at the rear of the frame
(Figure 23).
4. Remove the third mounting bolt and
washer from the front of the frame on
the outer edge near the bearing
housing.
5. Slide the bottom shield out from
under the lip of
the side shield and remove it.
6. When reinstalling the bottom shield,
be sure to tuck it under the lip of the
side shield first, then finish positioning it and install the mounting hardware.
WARNING! Before performing any maintenance procedure, stop the
engine and disconnect the spark plug wire.
WARNING! Before performing any maintenance procedure, stop the
engine and disconnect the spark plug wire.