Filter
Top Products
CONAIR
MARTIN
05-15-96 79 9
3. Loosen the two collar nuts (1) which retain the screen holder.
4. Lower the link screws (2a, 2b) against the screen and lift out the screen
holder.
5. Lower the link screws against the inside (as for 2b) of the cutter housing and
lift out the screen for cleaning or changing the knives.
Hopper:
1. Release the protective cover or inlet funnel by pushing down the locking
clamp (2) and pulling the funnel axially over the locking clamp. The safety
switch's locking clamp is released, which cuts off the current to the screw
motor and prevents the granulator from being operated with the hopper
open.
5.3 Electrical connection
The granulator should be connected up by an authorised
electrician.
Connect the granulator to the mains supply. See Electrical scheme,
chapter␣ 9, connecting (Q1).
All connected electric motors have been set up with the intended rotation
direction by setting up the internal electrical connection for clockwise rotating
field.
• Using a phase-sequence indicator, check that the incoming phases are
connected to the granulator so that the intended, clockwise rotating field is
maintained.
1
2a
2b