Filter
Top Products
CONAIR
MARTIN
05-15-96 79 15
• Loosen the screws and remove the stirrup (A),
fasten the knife again. In this position the
primary relief angle, 35
0
, is sharpened.
• The knives can be sharpened only as
much as is shown in the adjacent
figure. After that, they are worn out
and should be replaced by new ones in
order for the granulation to be
effective.
Rotating knives:
NOTE: All rotating knives should be sharpened
equally so that the cutter does not become
unbalanced.
• The rotating knife is fastened with the stirrup (A)
under the lower part of the knife, as shown in the
adjacent figure, right part. Ball washers should be
used when tightening. In this position the
secondary relief angle, 40
0
, is sharpened.
A