Filter
Top Products
- Eng 10 -
HOW TO SET THE CLOCK
The device is equipped with a built-in clock allowing you to record
your pressure readings with time and date information. Set the
clock properly to keep a precise record of the time and date of your
measurement results. The clock-setting procedure goes in the
following order: Year/Month/Date and then Hour/Minute.
The clock has been factory preset to 12:00AM on January 1, 2004.
After batteries have been replaced, the clock will indicate the time
and date of the most recent measurement data in memory.
1
After making sure that the power is
turned off, press and hold for
more than a second.
The last figure of the Year (A.D.) will appear on the
pulse display section and Month/Date will appear
on the Time/Date display section.
The
“ ”
Year blinks and then will be corrected.
2
Set the “Year”.
Press to set the current year.
* The “ ”Year can be set between 04(2004)and
33(2033).
Press .
This will finalize the “ ”Year setting. The digits
representing the “ ”Month On the date display
section will flash.
Example: Set the clock to 08:05 PM on May 1, 2004.