Filter
Top Products
- Eng 16 -
AUTOMATIC CHANGEOVER FEATURE
● Press “POWER/MEASURE” switch after the comple-
tion of blood pressure measurement to revert the
display to the time display. If you do not press the
switch and leave the unit, the “Automatic changeover
feature” of the unit will work approximately three
minutes later to automatically revert the display to
the time indication. If you leave the unit for three
minutes without performing operations, the display
will automatically changeover to the time indication.
HOW TO CALL UP THE VALUES STORED IN MEMORY TO THE DISPLAY
● Except for the case where the unit is engaged in measurement, press “MEMORY” access switch to
call up the values (measurement results) stored in memory to the display.
● The value stored in memory is numbered in the order of measurements. For example, when 30 sets
of data are stored in memory, the data number 30 represents the latest data.
Data number: 1, 2, 3 ... ... 29, 30
cc
The earliest data The latest data
● The number of measurements that can be stored in memory is 30 sets. Then, when storing 31st
data in memory, the 1st data stored in memory will be automatically deleted. In this way, the unit
automatically delete data stored in memory in order of storage to accept new data.
● If you press “MEMORY” call switch with no data stored in memory, the clock indication will remain
on the display.