Filter
Top Products
9
Please note: the adhesive tape will not work on
dirt-repellent surfaces.
Cleaning recommendations
• After brushing, rinse your brushhead
thoroughly under running water.
• Remove the brushhead from the handle and
clean both parts separately under running
water. Then wipe them dry before you put the
handle on the charging unit.
• Before cleaning your charging unit, make sure
you disassemble it first. The charging ring and
the SmartPlug should never be placed in the
dishwasher. However, all other parts (base
station, base plate and protective cover) are
dishwasher-safe.
• From time to time, you can also clean
the charging ring, the SmartPlug and the
SmartGuide display unit with a damp cloth.
The SmartPlug charger and the SmartGuide
display unit should never be placed in water.
Synchronizing
In order to avoid interference of display
messages when using more than one Oral-B
Triumph toothbrush with separate SmartGuide
display units in the same household, you need
to assign the handles to their respective display
units. Please follow the steps below:
• Push the «h/min» button in the battery
compartment for at least 3 seconds. The
SmartGuide display unit shows «L---», in-
dicating the «Learn» mode for synchronization
is activated.
• Now you are requested by a flashing
on/off button in the toothbrush icon on the
SmartGuide display unit to turn the handle on.
When doing so, the automatic synchronization
process starts. It is finished when «L-1-» is
displayed.
• Then turn off the handle.
If you would like to assign a second handle to
the same SmartGuide display unit, repeat the
last two steps described above with the other
handle. You can exit the «Learn» mode by
pressing the «h/min» or «set» button. Otherwise
the «Learn» mode will automatically end after
30 seconds.
Please note:
– A maximum of 2 handles can be
synchronized with one SmartGuide display
unit. After you synchronized the second
handle, «Full» will be displayed.
– When changing batteries of the SmartGuide
display unit, stored data will be erased.
Therefore, please repeat the synchronization
process every time you change the batteries.
Deactivating the radio
transmission
If you want to use or carry your toothbrush in
surroundings where radio controlled appliances
are not allowed (e.g. hospitals or aircraft),
deactivate the radio transmission first.
To do so, simultaneously press the on/off and
mode button for 3 seconds. The handle display
shows the radio deactivation icon. If you want to
set
h/min
3 sec.
set
h/min
3 sec.
3738161_D30_NA.indd 93738161_D30_NA.indd 9 15.05.2007 15:00:11 Uhr15.05.2007 15:00:11 Uhr